Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Kawasaki
    3. :
  3. Z750r
    4. : Replacement engine oil and oil filter for Kawasaki z750r from 2008 to 2014

Model: Kawasaki Z750r
Part: Engine oil
Replacement engine oil and oil filter for Kawasaki z750r from 2008 to 2014

Descriptive guide for replacing the engine oil and oil filter of a Kawasaki z750R from 2008 to 2014. Get 4LT of motul 7100 10w40 oil, kawasaki oil filter 16097-0008 and copper washer with external diameter 20mm and internal diameter 13mm 1mm thick. Place the motorcycle on the rear stand. Start the engine, heat up to 70 degrees and turn off. Place a container for the recovery of the oil to be disposed of under the engine. Remove the tip if present. On the left side of the bike, unscrew the engine oil drain plug with the aid of a ratchet and a 17mm socket. Let all the oil drain. In the meantime, carefully clean the magnetic cap and replace the copper gasket. With a band wrench, unscrew the oil filter located in front of the engine between the exhaust manifolds. Wet the gasket of the new filter with a little oil and screw it, first by hand, then by one turn with the band wrench. Screw in the oil drain plug. Open the oil filler neck located on the engine crankcase, right side. First pour three liters of oil (the manufacturer declares 3.8LT dry engine, you base yourself between 3.3 and 3.8 LT), then add the remaining oil according to the oil level inspection hole at the bottom. Start the engine, let it warm up and switch off. Once the engine is cold, check the oil again, always with the bike in a straight position on the rear stand.


Posted on 12 November 2023 by ScegliAuto

How to remove the seat and the helmet compartment of the Peugeot Speedfight 2

We are going to illustrate below the main instructions that will allow us to disassemble and replace the seat and the helmet compartment of the Peugeot Speedfight 2 scooter. First of all we put our scooter on the central stand and begin to unscrew the fixing screws that we find on the sides of the compartment. helmet holder; we then unscrew the seat screws to remove it, as shown in the video. At this point we unscrew the petrol cap and remove the lateral plastic parts of the compartment, thus accessing the upper part of the engine; then let's reassemble everything, applying the reverse procedure!

Watch the video!


by ScegliAuto

More videos