Do it yourself
Frequently asked questions about cars and motorcycles
To replace the headlamp bulb on the Kawasaki Ninja 300, rotate the handlebars in the opposite direction of the bulb to be replaced. This will allow you to remove the cap that protects the inner part of the bulb. Once the cap is removed, disconnect the connector and pull the old bulb out of its housing. After the old bulb is removed, insert the new one and secure it with the retaining clip. Finally, reconnect the connector and close the protective cap.

Updated on 22 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Ninja 300 Today we will see the instructions on how to remove and replace the front headlight bulb on a Kawasaki Ninja 300. To perform the operation, first tur…
Ninja 300 To replace the headlight bulb on the Kawasaki Ninja 300, access the inside of the headlight from the back of the front fork, just below the handlebar…
Ninja 300 To replace the headlight bulb on a Kawasaki Ninja 300, access the interior of the headlight from the rear of the front fork, just below the handlebar…

How to Service the Beta RR 350

This video will illustrate the steps to perform the routine maintenance service, replacing the engine oil and oil filter on the Beta RR 350 enduro bike. First, place the bike on a stand and start by loosening the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then clean the small oil filter (replacing it with a new one if too dirty). Finally, top up with new oil, of the correct type for your engine, filling to the maximum level!

Watch the video!


by ScegliAuto

More videos