Do it yourself
| ||||
|
Model: Kawasaki Zx 6r
Let's find out in this guide how to disassemble and replace the rear wheel bearing of the Kawasaki Zx 6R, following the instructions below. First of all we lift the rear wheel from the ground, using the stand, and we begin to disassemble the wheel, unscrewing the central pin; then we disconnect the chain and unscrew the brake disc screws to remove it, as shown in the video. At this point we remove the old bearing with an extractor, replacing it with the new one; let's insert it until it reaches the stop and finally reassemble the disc and the rear wheel!
Posted on 16 May 2024 by ScegliAuto
|
How do you bleed the Gilera Nexus 500 brakes?In order to bleed the Gilera Nexus 500 brakes, you need to open the drawer that is located in correspondence with the knob, unscrewing the fixing screws of the cover. Once this has been opened, it will be possible to insert a small tube inside the vent on the brake caliper: therefore, by opening the valve, the brake fluid can be collected inside a container. When all the fluid has flowed out, it will be possible to fill in the new brake oil from the vent that was previously opened by removing the cover next to the knob. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.007
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |