Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Clear Error Codes Without a Scanner on the Kawasaki Ninja ZX-10R

Model: Kawasaki Ninja Zx 10r
Part: Warning light – error code

Video tutorial

In this video, learn how to clear error codes on the Kawasaki Ninja ZX-10R without needing a scanner: start the bike and let it idle for about 10 seconds; you can use the stopwatch on the bike to time the seconds; after this, put it in first gear and ride the bike for about 10 minutes.

You must repeat this process three times.

Between each cycle, turn off the bike and restart it, allowing it to run for the 10 seconds mentioned at the beginning. After completing this procedure three times, on the fourth start, the error codes will be cleared.

This system certainly works for the 2018 and 2019 models.


Updated on 13 September 2026 by ScegliAuto


Related tutorials

How to Access the Fuse Box of the Kawasaki Ninja ZX-10R
How to Access the Fuse Box of the Kawasaki Ninja ZX-10R
Ninja Zx 10r In this guide, you will learn how to access the fuse box of the Kawasaki Ninja ZX-10R motorcycle. First, place the bike on a stand and start removing…
How to change the engine oil in the Kawasaki Ninja ZX-10R?
How to change the engine oil in the Kawasaki Ninja ZX-10R?
Ninja Zx 10r In this tutorial, you will see how to change the engine oil in the Kawasaki Ninja ZX-10R, a very simple and quick operation. First, wait until the en…
How do you replace the air filter of the Kawasaki Ninja ZX-10R?
How do you replace the air filter of the Kawasaki Ninja ZX-10R?
Ninja Zx 10r It will be possible to replace the air filter of the Kawasaki Ninja ZX-10R by loosening the screws that secure the side panels of the motorcycle loca…

How to change the engine oil of a Yamaha MT-07?

To change the engine oil of a Yamaha MT-07, follow these steps. Start by placing the bike on a flat surface and ensure the engine is warm but not too hot. Remove the oil cap from the top of the engine and unscrew the oil drain plug on the engine casing, usually located on the underside of the engine. Position a collection container under the drain plug and unscrew the plug to completely drain the used oil. Once drained, refit the drain plug. Remove and replace the oil filter using an oil filter spanner. Apply a little new oil to the seal of the new filter before installation. Fill the engine with new oil through the oil opening until reaching the recommended level. Check the oil level using the dipstick and add oil if necessary. Refit the oil cap and ensure it is securely tightened. Start the engine and let it run for a few minutes to distribute the oil, and you will have completed the procedure.

Watch the video!


by ScegliAuto

More videos