Do it yourself
Frequently asked questions about cars and motorcycles

Guide to Removing Speakers and Related Wiring

Model: Kia Sportage JA, MK 1 - Years 1993-2002
Part: Speaker

You may encounter issues with the audio system or want to replace the speakers with more powerful ones. Let's detail the steps for removing and possibly replacing them, and how to install wiring to connect the stereo audio to a caravan or trailer. Open the boot lid, starting from the driver's side, and remove the cover panel by pulling it towards you from the designated slot. To remove the speaker, unscrew the screws and disconnect the wiring as shown in the guide. If you want to replace it, you can carefully pull it out; otherwise, the video shows how to connect the cable that will carry audio to the trailer. The wiring is housed within the plastics of the boot; to remove them, simply unscrew all the screws indicated in the video and repeat the same procedure for the passenger side speaker.

Updated on 1 February 2026 by ScegliAuto

This video is currently unavailable

Related tutorials

Kia Sportage (2016-2022 / QL, MK 4) Today we will explain how to replace the speakers of the 2018 Kia Sportage car radio by yourself. To replace the speakers, open the front doors on th…
Kia Sportage (2010-2016 / SL, MK 3) Removing the rear spring from the Kia Sportage? Here’s how to remove the rear shock absorber. Lift the car on a column lift and remove the rear wheel…
Kia Sportage (2004-2010 / MK 2, KM) Before removing the windscreen washer reservoir, you must remove the front bumper. If you are unsure how to do this, refer to our other tutorials, bu…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos