Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Carburettor from the KTM EXC 525

Model: Ktm Exc 525
Part: Carburetor

Video tutorial

In this brief guide, we will see the instructions that will allow us to remove and possibly replace the carburettor of the KTM EXC 525 motorcycle. First, place the bike on a stand and start by removing the rider's seat; then loosen the clamp on the carburettor's intake manifold, disconnecting the fuel line and throttle cable, as shown in the video.

At this point, disconnect the air filter box from the carburettor, removing it and replacing it with a new one if necessary; then reassemble and reconnect the carburettor!


Posted on 21 February 2026 by ScegliAuto


Related tutorials

How to Install the Clutch on a KTM EXC 525
How to Install the Clutch on a KTM EXC 525
Exc 525 Today, we will see, in this video tutorial, how to install the clutch discs and bell on a KTM EXC 525, following the instructions below. First, clean…
Change the Engine Oil and Oil Filter on a KTM EXC 525
Change the Engine Oil and Oil Filter on a KTM EXC 525
Exc 525 Today, follow these step-by-step instructions to perform routine maintenance by changing the engine oil and oil filter on the KTM EXC 525 enduro bike…
How to Replace the Engine Oil and Oil Filter of the KTM EXC 525
How to Replace the Engine Oil and Oil Filter of the KTM EXC 525
Exc 525 Follow these instructions to drain and refill the engine oil of the KTM EXC 525 enduro bike. First, place your bike on a stand and start the drainage…

How to Replace the Wing Mirror on a Harley Davidson Sportster

To replace the wing mirror on a Harley Davidson Sportster, loosen the nut located at the base of the mirror, at the bottom of the handlebars. Once this nut is fully loosened, you can slide out the pin that secures the mirror to the handlebars, completely removing the old mirror from its housing and replacing it with a new replacement part. The new mirror should be positioned, inserting the corresponding pin, and finally secured by tightening the nut at the bottom of the handlebars.

Watch the video!


by ScegliAuto

More videos