Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Front Headlamp Bulb on the KTM SM 690

Model: Ktm Sm 690
Part: Headlight bulb

Video tutorial

In this video tutorial, follow the instructions to remove and replace the front headlamp bulb on the KTM SM 690. First, unscrew all the fixing screws located on the sides of the headlamp to detach it and pull it forward, allowing access to the bulb.

Next, remove the rubber protective cap and disconnect the electrical connector of the bulb.

At this point, release the metal clip and extract the old bulb, replacing it with the new one of the correct type (in this case, an H4 bulb)!


Updated on 18 April 2026 by ScegliAuto


Related tutorials

How to Replace the Rear Wheel of the KTM 690 SMCR
How to Replace the Rear Wheel of the KTM 690 SMCR
Sm 690 This guide explains how to remove and replace the rear wheel or tyre of the KTM SMCR 690 motorcycle. First, place the motorcycle on a stand and lift …
How to Replace the Rear Brake Pads on a KTM SM 690
How to Replace the Rear Brake Pads on a KTM SM 690
Sm 690 Let’s look at how to quickly and easily remove and replace the rear brake pads on the KTM SM 690. First, place the bike on a stand and start by remov…
How to Replace the Air Filter on the KTM SM 690
How to Replace the Air Filter on the KTM SM 690
Sm 690 Discover in this brief guide the steps to remove and replace the engine air filter of the KTM SM 690 motorcycle, in simple and quick steps. First, re…

How to Change the Engine Oil on a Benelli 150

To change the engine oil on a Benelli 150, ensure the bike is on a stable surface, using the centre stand to keep it upright. Before starting, it's helpful to run the engine for a few minutes to warm the oil and facilitate drainage. Turn off the engine and locate the drain plug situated under the engine. Using an appropriate spanner, loosen the plug and position a container underneath to collect the used oil. Allow it to drain completely, ensuring all the liquid is removed. Once emptied, carefully re-tighten the plug, avoiding overtightening. Using a funnel, slowly pour new oil into the tank, checking the level with the dipstick or inspection window. When the level is correct, start the engine for a couple of minutes to circulate the new oil, then turn it off and check the level again, topping up if necessary.

Watch the video!


by ScegliAuto

More videos