Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Grips on the 2016 KTM EXC 250

Model: Ktm Exc 250
Part:

Video tutorial

In this video tutorial, you will learn how to remove and replace the grips on the 2016 KTM EXC 250, following the instructions below. First, remove the old grips; to extract them, pull firmly outwards: if they are difficult to remove, proceed to cut them off, as shown in the video.

At this point, clean the handlebars of any dirt and grease; then lightly lubricate the new grips to facilitate their insertion: push them on until they are fully seated (opt for non-slip grips of the correct size).


Updated on 21 April 2026 by ScegliAuto


Related tutorials

How to Replace the Coolant on the KTM 250 EXC (2016)
How to Replace the Coolant on the KTM 250 EXC (2016)
Exc 250 In this video tutorial, you will learn how to replace the coolant or antifreeze on a 2016 KTM EXC 250 in simple and quick steps. First, bleed the coo…
How to Replace the Front Wheel on a KTM Exc 250
How to Replace the Front Wheel on a KTM Exc 250
Exc 250 The following steps will guide you through removing and replacing the front wheel on the KTM Exc 250 enduro bike, as well as the Exc 300 and Exc 125 …
How to Replace the Rear Brake Pads on the KTM EXC 250
How to Replace the Rear Brake Pads on the KTM EXC 250
Exc 250 This guide provides instructions to remove and replace the rear brake pads on the KTM EXC 250 enduro motorcycle, as well as the EXC 300 and XC models…

How to replace the air filter in a Suzuki Burgman scooter?

As we can see in this tutorial, replacing the air filter in the Suzuki Burgman 650 scooter is an extremely simple and quick operation. Before proceeding, ensure the engine is completely cold for safety. Start by opening the small glove compartment located under the handlebars, then remove the panel on the opposite side. Next, unscrew the 4 screws indicated with a simple cross-head screwdriver, remove the relay box, and extract the filter from the housing using pliers. Once the replacement is inserted, you can follow the reverse procedure to reassemble everything.

Watch the video!


by ScegliAuto

More videos