Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the ECU from the KTM EXC 500

Model: Ktm Exc F 500
Part: Control unit

Video tutorial

In today's tutorial, you will learn how to remove and replace the engine control unit (ECU) of the KTM EXC 500 enduro bike by following these simple and quick steps. First, remove the rider's seat and disconnect the electrical connector of the ECU located underneath by releasing the plastic tab with something thin; then remove the ECU as shown in the video.

At this point, replace the ECU with the new one, using the original spare part; then reassemble everything by applying the reverse procedure!


Updated on 18 May 2026 by ScegliAuto


Related tutorials

How to change the engine oil on a KTM EXC 500 2022
How to change the engine oil on a KTM EXC 500 2022
Exc F 500 In this tutorial, you will learn how to perform the first service of the routine maintenance for the oil change on the KTM EXC 500 enduro bike, in si…
How to Replace the Clutch on the KTM EXC-F 500?
How to Replace the Clutch on the KTM EXC-F 500?
Exc F 500 To replace the clutch on the KTM EXC-F 500, loosen the screws securing the specific cover located on the left side of the bike in the lower central a…
How to Replace the Front Wheel of a KTM EXC 500
How to Replace the Front Wheel of a KTM EXC 500
Exc F 500 Today, in this brief and simple guide, we will provide instructions for removing and replacing the front wheel of the KTM EXC 500 enduro bike. First,…

How to Replace the O-ring on the Clutch Rod of the LML Star?

To replace the O-ring on the clutch rod of the LML Star, lift the bike to loosen the side panel located near the rear wheel. Next, unscrew all the screws securing the rear wheel and the corresponding transmission cover: by removing the clutch, you will be able to locate the rod positioned behind it. This rod can now be removed from its housing by unscrewing the fastening screws; after the old rod has been removed, slide out the O-ring, replace it with a new one, and reassemble all previously removed components.

Watch the video!


by ScegliAuto

More videos