Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Change the Engine Oil in a KTM EXC-F 500?

Model: Ktm Exc F 500
Part: Engine oil

Video tutorial

Changing the engine oil in the KTM EXC-F 500 is an extremely simple and quick operation; let's see how to proceed in this tutorial. First, wait for the engine to be completely cold, then remove the lower cover and place a container underneath.

Next, unscrew the drain bolt, allowing all the oil in the system to drain out, and proceed with replacing the filter, which is located on the left side of the engine. Finally, tighten every bolt and insert the required amount of oil through the hole on the right side.


Updated on 29 June 2026 by ScegliAuto


Related tutorials

How to change the engine oil on a KTM EXC 500 2022
How to change the engine oil on a KTM EXC 500 2022
Exc F 500 In this tutorial, you will learn how to perform the first service of the routine maintenance for the oil change on the KTM EXC 500 enduro bike, in si…
How to Change the Engine Oil of the Ktm Exc 500
How to Change the Engine Oil of the Ktm Exc 500
Exc F 500 In this brief and simple guide, we will outline the procedure to change the engine oil and oil filter of the Ktm Exc 500 enduro bike. First, place th…
How to Change the Engine Oil on the KTM EXC-F 500
How to Change the Engine Oil on the KTM EXC-F 500
Exc F 500 .. the routine maintenance service on the KTM EXC-F 500 enduro bike. First, remove the oil drain bolt located under the engine, allowing the oil to drain.. …

How to Replace the O-ring on the Clutch Rod of the LML Star?

To replace the O-ring on the clutch rod of the LML Star, lift the bike to loosen the side panel located near the rear wheel. Next, unscrew all the screws securing the rear wheel and the corresponding transmission cover: by removing the clutch, you will be able to locate the rod positioned behind it. This rod can now be removed from its housing by unscrewing the fastening screws; after the old rod has been removed, slide out the O-ring, replace it with a new one, and reassemble all previously removed components.

Watch the video!


by ScegliAuto

More videos