Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Ktm
    3. : Smr 690

Engine Oil and Oil Filter Replacement for the KTM SMR 690

Model: Ktm Smr 690
Part: Engine oil

Video tutorial

The routine maintenance service, including the engine oil and oil filter replacement, must always be performed at the intervals specified by the manufacturer; therefore, we will carry out the service on the KTM SMR 690. First, place your bike on a stand and start unscrewing the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes.

Then, unscrew the oil filter covers, removing and replacing the cartridges with new ones.

Finally, unscrew the filler cap and top up with new oil suitable for your engine!


Updated on 27 July 2026 by ScegliAuto


Related tutorials

How to Perform an Oil Change and Filter Replacement on the Ktm 690 Enduro R
How to Perform an Oil Change and Filter Replacement on the Ktm 690 Enduro R
690 Enduro R In today's video, we will see step-by-step instructions to perform the service, which includes the routine maintenance oil change and oil filter repl…
Replacing Engine Oil and Oil Filter on KTM SMC R 690
Replacing Engine Oil and Oil Filter on KTM SMC R 690
Smc 690 Today we will replace the engine oil and oil filter, performing the regular maintenance service on a KTM SMC R 690, following the instructions below.…
Changing Engine Oil and Oil Filter on KTM Duke 690
Changing Engine Oil and Oil Filter on KTM Duke 690
Duke 690 In this video tutorial, we will see how to change the engine oil and oil filter on a KTM Duke 690, performing the regular maintenance service. First,…

How to change the transmission oil on the Honda PCX 150 scooter?

In this tutorial, you will see how to change the transmission oil on the Honda PCX 150 scooter, a very simple and quick operation. First, ensure the engine is completely cold, then locate the three bolts at the end of the casing and position a container underneath them. Next, remove the two inner bolts using a 12 mm socket, clean them of any dirt, and allow all the oil in the system to drain out. At this point, tighten the lower bolt and, using a pump or syringe, add new oil through the upper hole.

Watch the video!


by ScegliAuto

More videos