Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Ktm
    3. : Xcw 150

How to Replace the Spark Plug on the KTM XCW 150

Model: Ktm Xcw 150
Part: Spark plugs

Video tutorial

To replace the spark plug on the KTM XCW 150, loosen the screws securing the seat to the bike frame so that you can completely detach it along with the fairings on either side and above the fuel tank. Once these panels are removed, locate the ignition coil at the top of the cylinder.

Disconnect the coil to extract the spark plug from its housing using a socket tool, then insert the new replacement part. After the replacement, refit all the components removed earlier.


Updated on 2 September 2026 by ScegliAuto


Related tutorials

How do you replace the exhaust pipe of the KTM XCW 150?
How do you replace the exhaust pipe of the KTM XCW 150?
Xcw 150 In order to replace the exhaust pipe of the KTM XCW 150, you need to loosen the screws that hold it in place on the right side of the bike, near the …

How to Change the Engine Oil on a Benelli 150

To change the engine oil on a Benelli 150, ensure the bike is on a stable surface, using the centre stand to keep it upright. Before starting, it's helpful to run the engine for a few minutes to warm the oil and facilitate drainage. Turn off the engine and locate the drain plug situated under the engine. Using an appropriate spanner, loosen the plug and position a container underneath to collect the used oil. Allow it to drain completely, ensuring all the liquid is removed. Once emptied, carefully re-tighten the plug, avoiding overtightening. Using a funnel, slowly pour new oil into the tank, checking the level with the dipstick or inspection window. When the level is correct, start the engine for a couple of minutes to circulate the new oil, then turn it off and check the level again, topping up if necessary.

Watch the video!


by ScegliAuto

More videos