Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Clutch on a KTM SX-F 450?

Model: Ktm Sx F 450
Part: Clutch

Video tutorial

To replace the clutch on the KTM SX-F 450, loosen the screws securing the clutch cover located on the right side of the bike. Once the screws are loosened, you can completely remove the old cover to access the underlying clutch plates.

These can now be fully extracted to allow for the installation of new replacement parts. After replacing them, refit the cover to check the operation of the clutch.


Updated on 18 September 2026 by ScegliAuto


Related tutorials

How to Replace the Battery on a KTM SX-F 450
How to Replace the Battery on a KTM SX-F 450
Sx F 450 .. To replace the battery on a KTM SX-F 450, you need to loosen the bolts securing the seat on the left and right sides. Once these bolts are.. …
How to Replace the Battery on the KTM SX-F 450
How to Replace the Battery on the KTM SX-F 450
Sx F 450 .. To replace the battery on the KTM SX-F 450, loosen the bolts located on the side of the seat to remove it. Once the seat is removed, disconnect.. …
How to Replace the Exhaust of the KTM SX-F450?
How to Replace the Exhaust of the KTM SX-F450?
Sx F 450 .. To replace the exhaust of the KTM SX-F 450, loosen the two screws that secure it to the appropriate mounts: these screws will be located at.. …

How to Change the Engine Oil on a Benelli 150

To change the engine oil on a Benelli 150, ensure the bike is on a stable surface, using the centre stand to keep it upright. Before starting, it's helpful to run the engine for a few minutes to warm the oil and facilitate drainage. Turn off the engine and locate the drain plug situated under the engine. Using an appropriate spanner, loosen the plug and position a container underneath to collect the used oil. Allow it to drain completely, ensuring all the liquid is removed. Once emptied, carefully re-tighten the plug, avoiding overtightening. Using a funnel, slowly pour new oil into the tank, checking the level with the dipstick or inspection window. When the level is correct, start the engine for a couple of minutes to circulate the new oil, then turn it off and check the level again, topping up if necessary.

Watch the video!


by ScegliAuto

More videos