Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Fuel Pump on a KTM RC 200

Model: Ktm Rc 200
Part: Fuel pump

Video tutorial

Follow these brief steps to remove and replace the fuel pump on a KTM RC 200 motorcycle. First, place the bike on a stand and remove the plastic cover from the fuel tank, then also remove the battery.

Next, unscrew the fairing screws and then the tank screws to remove it, as shown in the video. At this point, unscrew the fuel pump mounting screws located underneath and replace it with the new original one. Also, replace the fuel filter, following the video tutorial to the end for reassembly!


Updated on 22 September 2026 by ScegliAuto


Related tutorials

How to Replace the Clutch on a KTM RC 200?
How to Replace the Clutch on a KTM RC 200?
Rc 200 To replace the clutch on a KTM RC 200, loosen the cover panel located on the right side of the bike, in the lower central area. Once the panel is rem…
How to Replace the Rear View Mirror on a KTM RC 200?
How to Replace the Rear View Mirror on a KTM RC 200?
Rc 200 To replace the rear view mirror on a KTM RC 200, loosen the two screws located on the side of the front fairing: these screws should be loosened usin…
How to replace the grips on the KTM RC 200?
How to replace the grips on the KTM RC 200?
Rc 200 To replace the grips on the KTM RC 200, you need to completely remove the covering of the old grips: to do this, cut the covering using a utility kni…

How to remove the panels of the Peugeot Kisbee

In this short and simple guide, you will see how to remove the plastic panels of the Peugeot Kisbee scooter, following the instructions provided below. First, place your scooter on the centre stand and begin by lifting the rider's seat; then, unscrew the fixing screws found in the under-seat compartment and under the footboard, subsequently removing the panels as shown in the video. At this point, unscrew the screws of the footboard to remove it, then remove the front shield (disconnecting the electrical connectors as well); finally, reassemble everything by applying the reverse procedure!

Watch the video!


by ScegliAuto

More videos