Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Change the Transmission Oil of the KTM EXC 300

Model: Ktm Exc 300
Part: Transmission fluid

Video tutorial

In a few simple steps, learn how to drain and refill the transmission oil of the KTM EXC 300 enduro bike. First, place the bike on a stand and start unscrewing the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then clean the drain plug of any metal debris before screwing it back in, as shown in the video.

Now, unscrew the fill cap and refill with new oil, following the specifications indicated in the owner's manual and inserting the correct quantity.


Updated on 10 October 2026 by ScegliAuto


Related tutorials

How to replace the transmission oil in the KTM Exc 300
How to replace the transmission oil in the KTM Exc 300
Exc 300 Today, let's discover how to carry out the routine maintenance service by replacing the transmission oil in the two-stroke enduro bike KTM Exc 300. F…
How to Perform the First Maintenance on the KTM Exc 300
How to Perform the First Maintenance on the KTM Exc 300
Exc 300 Today, discover the steps to perform the first maintenance on the KTM Exc 300 enduro bike, following the instructions below. First, place the bike on…
How to Change the Gear Oil in the KTM EXC-W 300
How to Change the Gear Oil in the KTM EXC-W 300
Exc 300 In this video, you will see how to change the transmission oil while performing the routine maintenance service on the KTM EXC-W 300 enduro bike. Fir…

How to Reset the Service Light on the Gilera Nexus 500

This video shows the procedure to reset the service light on the Gilera Nexus when the light remains on after a service. The procedure is straightforward and takes less than a minute. To reset the light, press the mode button and the odo/set button simultaneously. While holding them down, turn the ignition key to the ON position. Once the instruments are on, release the buttons and press the mode button once. The maintenance light will illuminate; hold the mode button for a few seconds to reset it.

Watch the video!


by ScegliAuto

More videos