Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How do you replace the coils of the Kymco Agility 50?

Model: Kymco Agility 50
Part: Ignition coil

Video tutorial

To replace the coils of the Kymco Agility 50, you will need to open the underseat compartment: in this way it will be possible to locate the corresponding compartment container. This can be released from the appropriate fixing screws and then proceed by loosening the panels on the sides: once these panels have been released, it will be possible to access the top of the engine.

The coils here must be disconnected from the corresponding connectors in order to insert the new ones: once the installation is complete, it will be necessary to check that everything is functioning properly.


Posted on 13 February 2025 by ScegliAuto


Related tutorials

How to change the oil of the Kymco Agility 50
How to change the oil of the Kymco Agility 50
Agility 50 In the following mini guide, we will discover together how to correctly change the oil of your Kymco Agility 50. First of all, make sure you have the…
How to Replace the Variator on the Kymco Agility 50?
Agility 50 To replace the variator on the Kymco Agility 50, loosen the screws securing the transmission cover located near the rear wheel on the left side of th…
How to Replace the Belt on the Kymco Agility 50
How to Replace the Belt on the Kymco Agility 50
Agility 50 To replace the belt on the Kymco Agility 50, loosen the bolts securing the cover of the transmission casing: this is located on the left side of the …

How to Change the Engine Oil of a BMW R9T

To change the engine oil of a BMW R9T, follow these steps. Ensure the engine is warm but not too hot. Position the bike on a flat surface and lift the front using a motorcycle stand. Remove the oil cap from the engine oil reservoir. Place a catch container under the oil drain plug, usually located on the underside of the engine. Unscrew the oil drain plug and let the old oil drain completely into the container. Once drained, re-tighten the oil drain plug. Remove the oil filter using an oil filter wrench. Clean the mounting surface of the filter and apply a bit of new oil to the seal of the new filter. Install the new oil filter. At this point, fill the engine with new oil, and you will have completed the replacement.

Watch the video!


by ScegliAuto

More videos