Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
It will be possible to replace the front brake pads of the Kymco Downtown 300i by unscrewing the screws that secure the brake caliper to the corresponding disc: this can now be detached in order to remove the pin that holds the pads in their housing. This way, the old pads can be extracted from their compartment so that the new ones can be positioned: these will need to be secured by inserting the pin and repositioning the caliper onto the disc. After securing it, it will be possible to check that everything is functioning correctly.

Posted on 8 January 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing Rear Brake Pads on Kymco Downtown 300i
Replacing Rear Brake Pads on Kymco Downtown 300i
Downtown 300i In today's tutorial, we will see how to remove and replace the front brake pads on a Kymco Downtown 300i scooter, in simple steps. First, position th…
Replacing the Rear Brake Pads on a Kymco Downtown 300i
Replacing the Rear Brake Pads on a Kymco Downtown 300i
Downtown 300i In this video, we will go through the steps to remove and replace the rear brake pads on a Kymco Downtown 300i ABS scooter. First, place the scooter …
How to Reset the "Service" Light on a Kymco Downtown 300i?
How to Reset the "Service" Light on a Kymco Downtown 300i?
Downtown 300i First, sit on the seat of your Kymco Downtown 300i. Start by activating the instrument panel by turning the key in the ignition switch. Next, press a…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos