Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replace Engine Oil and Gear Oil on the Kymco Agility 50

Model: Kymco Agility 50
Part: Engine oil

Video tutorial

In this video tutorial, you will learn how to change the engine oil and gear oil on the Kymco Agility 50 scooter in simple and quick steps. First, position the scooter on the centre stand and warm up the engine for a few minutes; then, unscrew the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes.

Next, move to the transmission cover and unscrew the gear oil drain screw; finally, pour in the two different oils, filling to the correct level!


Updated on 27 April 2026 by ScegliAuto


Related tutorials

How to change the oil of the Kymco Agility 50
How to change the oil of the Kymco Agility 50
Agility 50 In the following mini guide, we will discover together how to correctly change the oil of your Kymco Agility 50. First of all, make sure you have the…
How to Change the Engine Oil on a Kymco Agility 50
How to Change the Engine Oil on a Kymco Agility 50
Agility 50 Today, we will go through the instructions to change the engine oil and perform the routine maintenance service on the Kymco Agility 50 scooter. Firs…
Gear Oil Change on Kymco Agility 50
Gear Oil Change on Kymco Agility 50
Agility 50 As shown in the video, unscrew the lower bolt of the gearbox and also unscrew the side screw from where, in the end, we will insert the new lubricant…

How to Change the Engine Oil of a BMW R9T

To change the engine oil of a BMW R9T, follow these steps. Ensure the engine is warm but not too hot. Position the bike on a flat surface and lift the front using a motorcycle stand. Remove the oil cap from the engine oil reservoir. Place a catch container under the oil drain plug, usually located on the underside of the engine. Unscrew the oil drain plug and let the old oil drain completely into the container. Once drained, re-tighten the oil drain plug. Remove the oil filter using an oil filter wrench. Clean the mounting surface of the filter and apply a bit of new oil to the seal of the new filter. Install the new oil filter. At this point, fill the engine with new oil, and you will have completed the replacement.

Watch the video!


by ScegliAuto

More videos