Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
As shown in the video, unscrew the lower bolt of the gearbox and also unscrew the side screw from where, in the end, we will insert the new lubricant. Unscrew both immediately to allow air circulation and prevent a vacuum. It is also recommended to start the scooter for a few minutes before performing this task to warm up all the oil circulating in your Kymco. This will make it more fluid and easier to drain from the compartment. Drain the used oil into a container, close the lower hole, and fill with the same quantity of 75W-90 oil from the fill hole.

Updated on 25 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to change the oil of the Kymco Agility 50
How to change the oil of the Kymco Agility 50
Agility 50 In the following mini guide, we will discover together how to correctly change the oil of your Kymco Agility 50. First of all, make sure you have the…
Replace Engine Oil and Gear Oil on the Kymco Agility 50
Replace Engine Oil and Gear Oil on the Kymco Agility 50
Agility 50 In this video tutorial, you will learn how to change the engine oil and gear oil on the Kymco Agility 50 scooter in simple and quick steps. First, po…
How to Change the Engine Oil on a Kymco Agility 50
How to Change the Engine Oil on a Kymco Agility 50
Agility 50 Today, we will go through the instructions to change the engine oil and perform the routine maintenance service on the Kymco Agility 50 scooter. Firs…

How to Replace the Front Headlight on the BMW F800GS

In this tutorial, you will see how to replace the front headlight on the BMW F800GS, an extremely simple and quick operation. First, ensure the key is not inserted for safety, then locate the power connector at the back of the headlamp and disconnect it by pressing the clip. Next, unscrew the two side bolts using a Torx T40 key, grasp the headlight and pull it away from the support. At this point, you can insert the replacement, tighten the two bolts, and reconnect the power connector.

Watch the video!


by ScegliAuto

More videos