Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Reset the ECU on a Kymco Downtown 300i ABS

Model: Kymco Downtown 300i
Part: Warning light – error code

Video tutorial

In this brief guide, you will learn how to reset the ECU (Electronic Control Unit) on the Kymco Downtown 300i ABS scooter by following the instructions below. First, turn on the ignition by turning the key to position one. Then, fully twist the throttle grip for a couple of seconds until the yellow warning light appears on the rev counter, as shown in the video.

Now, turn off the ignition and then restart the engine; this will successfully reset the ECU!


Updated on 8 May 2026 by ScegliAuto


Related tutorials

How to Reset the ECU of the Kymco Downtown 300i
How to Reset the ECU of the Kymco Downtown 300i
Downtown 300i In this video tutorial, follow the instructions to reset the engine control unit (ECU) of the Kymco Downtown 300i scooter in simple and quick steps. …
How to Reset the "Service" Light on a Kymco Downtown 300i?
How to Reset the "Service" Light on a Kymco Downtown 300i?
Downtown 300i First, sit on the seat of your Kymco Downtown 300i. Start by activating the instrument panel by turning the key in the ignition switch. Next, press a…
How to Reset the Oil Service Light on Kymco Downtown 300i
How to Reset the Oil Service Light on Kymco Downtown 300i
Downtown 300i To reset the "SERVICE OIL" light on the Kymco Downtown 300i, follow this procedure. Insert the key and turn on the ignition (but not the engine), pre…

How to change the engine oil on the Aprilia Shiver 900?

To change the engine oil on the Aprilia Shiver 900, loosen the screws that secure the engine guard located at the bottom of the vehicle: once the screws are loosened, you can detach it and locate the drain plug of the oil sump. By removing this plug, you can collect all the used oil in a suitably placed container; at this point, allow all the oil to drain and remove the filter located at the bottom of the bike. Once the filter is replaced, top up the oil through the breather located on the right side of the bike.

Watch the video!


by ScegliAuto

More videos