|
Do it yourself
| |||
| ||||
|
Model: Kymco Xciting 300
To replace the spark plug on the Kymco Xciting 300, first disconnect the corresponding ignition coil located above the spark plug itself: to access the coil, you will need to work in the area between the transmission casing and the rear of the footwell. Once the coil is disconnected, you can also remove the spark plug from the top of the cylinder so that you can replace it with a new spare part; after the replacement, reconnect the ignition coil and check that the vehicle starts.
Updated on 25 July 2026 by ScegliAuto
Video tutorial
Related tutorials
Xciting 300
To replace the spark plug on this motorcycle model, follow the detailed steps below and you can also watch the video. First, remove the seat and the …
Xciting 300
To replace the exhaust pipe of the Kymco Xciting 300, you need to loosen the screws that hold it to its housing near the rear wheel, on the right sid…
Xciting 300
The transmission of the Kymco Xciting 300 can be replaced by loosening the screws that secure the transmission housing, located on the left side of t…
|
How to Service the Beta RR 350
This video will illustrate the steps to perform the routine maintenance service, replacing the engine oil and oil filter on the Beta RR 350 enduro bike. First, place the bike on a stand and start by loosening the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then clean the small oil filter (replacing it with a new one if too dirty). Finally, top up with new oil, of the correct type for your engine, filling to the maximum level! by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.007
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |