Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Kymco Gy6
Part: Starter motor

In this video, you will see how to remove the starter motor from a Kymco GY6: remove both bolts from the starter motor with an 8mm socket, using an extension, then disconnect the green earth cable and also remove the positive cable. Now, lever to remove the starter motor. You may need to gently tap it with a rubber mallet to get it out. You can find the starter motor on Amazon with the code B07KMDN1D4 for £22.00, including delivery charges. On this, you will install the power cables and refit the starter motor bolts after coating them with copper grease.

Updated on 21 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Starter Motor on Kymco Like 125?
How to Replace the Starter Motor on Kymco Like 125?
Like 125 To replace the starter motor on the Kymco Like 125, you will need to loosen the screws securing the corresponding cover located on the right side of …
Replacing the Starter Motor
Replacing the Starter Motor
Ford Mondeo / Fusion (1993-2000 / MK 1) The starter motor is a crucial electrical component that allows you to start your car. If your car won't start, one possible cause could be a faulty …
How to Replace Your Car's Starter Motor
How to Replace Your Car's Starter Motor
Volvo S70 (1996-2000 / MK 1) The starter motor is a crucial electrical component that allows you to start the car's engine. If you notice that the car won't start, it likely mean…

Changing the Oil and Filter on the Kawasaki Versys

Here’s how to change the oil and filter on the Kawasaki Versys. Warm up the engine for a few minutes, place the motorcycle on the centre stand, open the filler cap, and remove the drain plug underneath the engine. Place a catch basin under the oil sump, unscrew the drain plug, and let the oil drain out. Unscrew the oil filter and let all the old oil drain out. Install a new filter and tighten it with the appropriate tool. Pour half a glass of new oil into the filler cap and wait for it to flow out of the drain hole, after which replace the plug. Fill with approximately 1.8 litres of new oil, take it for a short ride to circulate the oil in the engine, stop the engine, and check the level through the designated window. Top up if necessary.

Watch the video!


by ScegliAuto

More videos