Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Lancia
    3. :
  3. Ypsilon
    4. : How to change the door pull on Lancia Ypsilon

Lancia Ypsilon - Video tutorial

Model: Lancia Ypsilon Y2, 843, Ypsilon 2, MK 2 - Years 2003-2011
Part: Door
Operation: How to change the door pull on Lancia Ypsilon

If we need to replace the car door locking rod, we can refer to the instructions below: stop the car on a flat surface so that the door can stay open and does not close by itself during the work, proceed to unscrew the Torx fixing screws both on the door and on the car frame, then proceed to remove the screws all around the door panel remove the cover located behind the rear view mirror fixing pin remove the screws located under the molding of the opening handle, remove the electric window button panel, and disconnect the connector, and then remove the whole panel by levering along the edges. Finally disassemble the loudspeaker and insert the arm inside the hole to be able to remove the tie rod in the flap.


Posted on 17 December 2022 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Ypsilon 2011-2023 - Why is the Lancia Ypsilon tailgate locked? Read Answer
    • Ypsilon 2011-2023 - Why doesn't the boot of the Lancia Ypsilon open? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos