Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Transmission Oil on an Lml Star 200 Scooter

Model: Lml Star 200
Part: Drivetrain

Video tutorial

How to replace the transmission oil on an Lml Star 200 scooter? Follow this guide to proceed with the replacement. Position the scooter on its original stand, and using a socket spanner, unscrew the drain plug of the transmission located under the casing (drain the fluid into a container).

Refit the drain plug into the casing. Unscrew the specific plug just above the drain plug (as shown in the video).

Top up with the new transmission fluid (fill with the correct amount of oil); close the casing with the tightening plug. Test the scooter's operation.

If necessary, replace the clutch springs.


Updated on 8 March 2026 by ScegliAuto


Related tutorials

How to replace the clutch on the LML Star 200?
How to replace the clutch on the LML Star 200?
Star 200 To replace the clutch on the LML Star 200, loosen the screws that secure the transmission cover located on the right side of the bike: once this cove…
How do you replace the timing chain of the LML Star 200?
How do you replace the timing chain of the LML Star 200?
Star 200 To replace the timing chain tensioner of the LML Star 200, you need to loosen the screws that secure the component to its housing: this will be locat…
How to Replace the Fuel Pump on an LML Star 200?
How to Replace the Fuel Pump on an LML Star 200?
Star 200 To replace the fuel pump on an LML Star 200, loosen the screws securing the right side cover panel of the bike, located near the rear wheel: once thi…

How to Reset the Service Light on the Gilera Nexus 500

This video shows the procedure to reset the service light on the Gilera Nexus when the light remains on after a service. The procedure is straightforward and takes less than a minute. To reset the light, press the mode button and the odo/set button simultaneously. While holding them down, turn the ignition key to the ON position. Once the instruments are on, release the buttons and press the mode button once. The maintenance light will illuminate; hold the mode button for a few seconds to reset it.

Watch the video!


by ScegliAuto

More videos