Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Air Filter in the LML Star 200

Model: Lml Star 200
Part: Air filter

Video tutorial

After securely positioning your LML Vespa, ensuring it is immobilised for safe working (to protect the operator's safety), the first step is to remove the spare tyre located on the left side of the engine compartment. To do this, undo the bolts holding it in place.

Now, locate the position of the filter, cut the tie that secures the connection between the bellows and the filter, and detach the filter itself. Undo the 4 screws securing the cover, and once removed, extract the cylindrical air filter.

Now, install the new filter, clean the cover and the gasket (or replace it), and reassemble everything in reverse order of the steps shown in the images. Thus, the operation is complete!


Updated on 10 April 2026 by ScegliAuto


Related tutorials

How do you replace the timing chain of the LML Star 200?
How do you replace the timing chain of the LML Star 200?
Star 200 To replace the timing chain tensioner of the LML Star 200, you need to loosen the screws that secure the component to its housing: this will be locat…
How do you replace the clutch of the LML Star 200?
How do you replace the clutch of the LML Star 200?
Star 200 To replace the clutch of the LML Star 200, you need to remove the side panel located on the right side of the rear wheel. Once this panel has been re…
How to Replace the Fuel Pump on an LML Star 200?
How to Replace the Fuel Pump on an LML Star 200?
Star 200 To replace the fuel pump on an LML Star 200, loosen the screws securing the right side cover panel of the bike, located near the rear wheel: once thi…

How to Reset the Service Light on the Gilera Nexus 500

This video shows the procedure to reset the service light on the Gilera Nexus when the light remains on after a service. The procedure is straightforward and takes less than a minute. To reset the light, press the mode button and the odo/set button simultaneously. While holding them down, turn the ignition key to the ON position. Once the instruments are on, release the buttons and press the mode button once. The maintenance light will illuminate; hold the mode button for a few seconds to reset it.

Watch the video!


by ScegliAuto

More videos