Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Rear Wheel of an LML Star 125

Model: Lml Star 125
Part: Wheel

Video tutorial

Before you can begin, position your LML Star 125 on the centre stand. Start by detaching and removing the left side panel.

Next, remove the spare wheel from its housing by unscrewing the securing bolts. This will expose all the bolts that secure the wheel to the hub. Proceed to unscrew and remove these bolts.

Once you have completed this step, you can extract and remove the wheel from the hub, finishing the disassembly.


Updated on 12 April 2026 by ScegliAuto


Related tutorials

Replace Rear Wheel on LML Star 125
Replace Rear Wheel on LML Star 125
Star 125 This video shows the main instructions for removing and replacing the rear wheel on an LML Star 125 in simple steps. First, position the vehicle on t…
How to replace the clutch and gear cables on the Lml Star 125 - Piaggio Vespa PX 125
How to replace the clutch and gear cables on the Lml Star 125 - Piaggio Vespa PX 125
Star 125 Let's look at the instructions that will allow you to remove and replace the clutch cable and the gear cables on the Lml Star 125, as well as the Pia…
How to Replace the Exhaust on the Piaggio Vespa PX 125 - LML Star 125
How to Replace the Exhaust on the Piaggio Vespa PX 125 - LML Star 125
Star 125 Below are the steps necessary to remove and replace the exhaust on the Piaggio Vespa PX 125 and the LML Star 125. First, place the central stand and …

How to Reset the Service Light on the Gilera Nexus 500

This video shows the procedure to reset the service light on the Gilera Nexus when the light remains on after a service. The procedure is straightforward and takes less than a minute. To reset the light, press the mode button and the odo/set button simultaneously. While holding them down, turn the ignition key to the ON position. Once the instruments are on, release the buttons and press the mode button once. The maintenance light will illuminate; hold the mode button for a few seconds to reset it.

Watch the video!


by ScegliAuto

More videos