Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the clutch and gear cables on the Lml Star 125 - Piaggio Vespa PX 125

Model: Lml Star 125
Part: Clutch

Video tutorial

Let's look at the instructions that will allow you to remove and replace the clutch cable and the gear cables on the Lml Star 125, as well as the Piaggio Vespa PX 125. First, remove the rear wheel to create more space; then, unscrew the nuts from the clutch cable adjuster, subsequently pulling the cable from the lever to remove and replace it. At this point, perform the same operation for the gear cables; before refitting them, it is necessary to apply grease to the cable to ensure it slides perfectly within the housings!


Updated on 4 July 2026 by ScegliAuto


Related tutorials

Replace the Gearbox Oil of the Lml Star 125 - Piaggio Vespa PX 125
Replace the Gearbox Oil of the Lml Star 125 - Piaggio Vespa PX 125
Star 125 .. gearbox oil of the Lml Star 125, as well as the Piaggio Vespa PX 125. First, place the central stand and start unscrewing the oil drain bolt located.. …
How to Replace the Engine Mounts on a Piaggio Vespa PX 125 - LML Star 125
How to Replace the Engine Mounts on a Piaggio Vespa PX 125 - LML Star 125
Star 125 .. the engine mounts or silent blocks on the Piaggio Vespa PX 125 and LML Star 125. To replace these mounts, remove the engine from the frame by.. …
Removing the Fuel Tank from an LML Star 125 - Piaggio Vespa PX
Removing the Fuel Tank from an LML Star 125 - Piaggio Vespa PX
Star 125 In this video, we will see how to remove the fuel tank from an LML Star 125, as well as from all 125-150-200 Piaggio Vespa PX models. First, lift the…

How to Reset the Service Light on the Gilera Nexus 500

This video shows the procedure to reset the service light on the Gilera Nexus when the light remains on after a service. The procedure is straightforward and takes less than a minute. To reset the light, press the mode button and the odo/set button simultaneously. While holding them down, turn the ignition key to the ON position. Once the instruments are on, release the buttons and press the mode button once. The maintenance light will illuminate; hold the mode button for a few seconds to reset it.

Watch the video!


by ScegliAuto

More videos