Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Engine Mounts on a Piaggio Vespa PX 125 - LML Star 125

Model: Lml Star 125

Video tutorial

This guide provides instructions for removing and replacing the engine mounts or silent blocks on the Piaggio Vespa PX 125 and LML Star 125. To replace these mounts, remove the engine from the frame by taking out the central pin; then use levers or appropriate pullers to remove the worn silent blocks, as shown in the video.

At this point, install the new mounts, lightly lubricating the sides to facilitate insertion; push the mounts until they are perfectly seated!


Updated on 13 August 2026 by ScegliAuto


Related tutorials

Replace the Gearbox Oil of the Lml Star 125 - Piaggio Vespa PX 125
Replace the Gearbox Oil of the Lml Star 125 - Piaggio Vespa PX 125
Star 125 .. service by replacing the gearbox oil of the Lml Star 125, as well as the Piaggio Vespa PX 125. First, place the central stand and start unscrewing.. …
How to Remove the Engine Block from the Piaggio Vespa PX 125 - Lml Star 125
How to Remove the Engine Block from the Piaggio Vespa PX 125 - Lml Star 125
Star 125 .. to remove the engine block from the frame of the Lml Star 125, as well as the Piaggio Vespa PX. First, place the central stand and start by removing.. …
How to Replace the Exhaust on the Piaggio Vespa PX 125 - LML Star 125
How to Replace the Exhaust on the Piaggio Vespa PX 125 - LML Star 125
Star 125 .. the exhaust on the Piaggio Vespa PX 125 and the LML Star 125. First, place the central stand and begin unscrewing the exhaust bolt connected to the.. …

How to Reset the Service Light on the Gilera Nexus 500

This video shows the procedure to reset the service light on the Gilera Nexus when the light remains on after a service. The procedure is straightforward and takes less than a minute. To reset the light, press the mode button and the odo/set button simultaneously. While holding them down, turn the ignition key to the ON position. Once the instruments are on, release the buttons and press the mode button once. The maintenance light will illuminate; hold the mode button for a few seconds to reset it.

Watch the video!


by ScegliAuto

More videos