Do it yourself
Frequently asked questions about cars and motorcycles
  1. Motorcycles
  2. :
  3. Lml
  4. :
  5. Star 125
  6. : How do you measure the oil level of the LML Star 125?

Model: Lml Star 125
Part: Engine oil
How do you measure the oil level of the LML Star 125?

In order to measure the oil level of the LML Star 125 it is necessary to extract the dipstick located in the lower part of the bike, near the rear wheel on the right side. To extract the dipstick, it is necessary to rotate it: once extracted it must be cleaned and inserted again in its seat in order to check the oil level. It is advisable to keep it about halfway between the maximum and the minimum. To top up, use an oil with the correct characteristics; the cap for topping up oil is located in the compartment under the saddle. Once the new oil has been added, it will be possible to check its level again.


Posted on 29 February 2024 by ScegliAuto



How to change the engine oil on a LML Star 125?
Star 125 To change the engine oil on an LML Star 125, start by placing the scooter on a flat surface and lifting it with a center stand to ensure stability. T
Change the gearbox oil of the Lml Star 125 - Piaggio Vespa PX 125
Star 125 Let's see today, in this short and simple guide, the steps that will allow us to carry out the routine maintenance service, replacing the transmissio
How to replace the fuel tank of the LML Star 125.
Star 125 Today's instructions will show us how to disassemble and replace the fuel tank of the LML Star 125, as well as the Piaggio Vespa PX 125. First, we pu

How to replace the battery of the Honda Forza 125

Today's steps will show you how to disassemble and replace the battery of the Honda Forza 125 scooter, following the instructions below. First, put the scooter on the center stand and start by opening the seat to access the battery; then disconnect both battery terminals (positive and negative), in order to remove it, as shown in the video. At this point, install the appropriate new battery, of the correct type and with the same amperage, making the connection; then check the engine ignition, and finally close the seat!

Watch the video!


by ScegliAuto

More videos