Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

DIY Engine Oil Change

Model: Lotus Elise MK 2 - Years 2004-2009
Part: Engine oil

To perform maintenance safely, lift the vehicle with a jack and place axle stands underneath. Then, unscrew the screws along the perimeter of the rear undertray corresponding to the engine and remove it.
At this point, place a flat container under the sump, unscrew the plug, and let the oil drain completely.
After tightening the sump plug, use a socket wrench to unscrew the filter plug, which will be replaced and screwed back into its housing.
Open the filler cap and pour in the new oil, ensuring not to exceed the level. Remount the undertray and the job is complete.

Updated on 1 February 2026 by ScegliAuto

Video tutorial

Related tutorials

How to reset oil change on Chevrolet Spark
How to reset oil change on Chevrolet Spark
Chevrolet Spark (2009-2016 / M300, MK 1) In this video tutorial we can see how to reset the oil light on Chevrolet Spark, following simple steps. When the change oil warning light comes on a…
Engine Oil and Filter Replacement
Engine Oil and Filter Replacement
Volkswagen New Beetle (1999-2012 / 9C, MK 2) Replacing the engine oil and its filter is typical DIY maintenance, but it is essential to dispose of the used oil at an authorised collection centre…
How to restore the oil change reminder on a 2015 Renault Master.
How to restore the oil change reminder on a 2015 Renault Master.
Renault Master (2010-2023 / MK 3) In this video tutorial, we can see how it is possible to reset the oil change reminder in a 2015 Renault Master, following a few simple steps: the fi…

Other guides you may be interested in

How to Clean the Injectors on BMW 3 Series

Let's see how to clean the injectors on BMW 3 Series with the appropriate cleaning kit. Lift the hood and secure it with the prop rod, then disconnect the fuel supply hose that leads to the injectors. Connect the pressure gauge and the cleaning kit to the fuel lines; start running the cleaning fluid from the previously connected kit through the fuel lines of the injectors (repeat this process several times). Disconnect everything and start the engine. Reinstall the fuel line leading to the injectors after cleaning them of any dirt and deposits.

Watch the video!


by ScegliAuto

More videos