Do it yourself
Frequently asked questions about cars and motorcycles

How do you change the gearbox oil on the Maxus T60?

Model: Maxus T60 MK 1 - Years 2016-2024
Part: Transmission fluid

In order to replace the gearbox oil of the Maxus T60 it is necessary to completely disassemble the gearbox, so that it is removed from the lower part of the car. After this disassembly has taken place, it will be necessary to loosen the screws that fix the oil sump: this will be removed and it will be possible to collect the old oil in a suitably positioned container. When the old oil has been removed, it will be possible to insert the new one inside the gearbox; finally it will be necessary to reassemble the gearbox inside its housing.

Posted on 29 November 2022 by ScegliAuto

This video is currently unavailable

Related tutorials

Maxus T60 (2016-2024 / MK 1) Below we will see the instructions that will allow us to install the plastic side covers to protect the rear bed of the Maxus T60, in simple and quic…
Maxus T60 (2016-2024 / MK 1) Today we will see, in this video tutorial, the instructions that will allow us to reset the service light of the ordinary maintenance of the oil chan…
Maxus T60 (2016-2024 / MK 1) In this guide, we will see the procedure that will allow us to disassemble and replace the timing belt of the Maxus T60 and MG T60. First, we open th…

How to Change the Diesel Filter on a Renault Captur 1.5 dCi

The diesel filter on the Renault Captur is always of the immersion type, but instead of being located at the top of the engine bay, it is positioned lower, inside the front right wheel arch (passenger side), practically under the headlamp. To replace it, it is advisable to lift the vehicle, remove the front right wheel and the corresponding inner lining to access the filter location. Unscrew the fastening nuts of the support clamp to extract it from its housing and disconnect the connector and pipes. At this point, unscrew the fixing screws of the cap, remove the old filter and insert the new one, also replacing the O-ring seals, and then reverse the steps for installation. Before starting the engine, turn the ignition on and off several times to allow the filter to fill.

Watch the video!


by ScegliAuto

More videos