Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. Classe A
    4. : Tie rods

Mercedes Classe A - Tie rods

Tie Rods Mercedes Classe A (2004-2012 / w 169)

Mercedes Classe A (2004-2012 / W169)
Remove Steering Tie Rod End on Mercedes A-Class
Are the tie rod ends damaged? Let's see how to remove them on a Mercedes A-Class. Position your car on a column lift and raise it to a comfortable working …Read all…
Posted on 13 April 2026 by ScegliAuto
Mercedes Classe A (1997-2004 / W168)
Steering Tie Rod End Replacement
To replace the ball joint of the tie rod end, lift the vehicle on a lift and remove the front wheel; then loosen the lock nut that secures the tie rod to the …Read all…
Posted on 24 February 2026 by ScegliAuto

Tie Rods Mercedes Classe A (1997-2004 / w 168)

Mercedes Classe A (2004-2012 / W169)
Remove Steering Tie Rod End on Mercedes A-Class
Are the tie rod ends damaged? Let's see how to remove them on a Mercedes A-Class. Position your car on a column lift and raise it to a comfortable working …Read all…
Posted on 13 April 2026 by ScegliAuto
Mercedes Classe A (1997-2004 / W168)
Steering Tie Rod End Replacement
To replace the ball joint of the tie rod end, lift the vehicle on a lift and remove the front wheel; then loosen the lock nut that secures the tie rod to the …Read all…
Posted on 24 February 2026 by ScegliAuto
Accelerator (1) Airbag (10) Alternator (4) Speaker (4) Shocks (6) Antenna (2) Air conditioning (1) Car stereo (30) Roof rack bars (1) Battery (36) Ignition coil (1) Air vents (4) Control arm (1) Grille (1) Transmission (10) Spark plugs (20) Glow plugs (5) Convertible top (1) Body (11) Glove compartment (1) Control unit (1) Wheel rim (1) Key (63) Timing belt (20) V-belt (6) Air conditioner (1) A/C controls (3) Onboard computer (8) Checks and maintenance (49) Dashboard (16) Shifter boot (1) CV boot (2) Bearing (2) Brake rotors (2) Rear bench seat (1) Headlight (13) Tail light (11) Air filter (14) Cabin air filter (27) Fuel filter (2) Diesel fuel filter (11) Oil filter (2) Clutch (3) Grille (3) Fuel injectors (4) Window switch (1) Accessory kit (2) Light bulb (12) Side marker bulb (2) Headlight bulb (21) Tail light bulb (10) Interior dome light bulb (5) Antifreeze coolant (1) Handle (5) Engine (3) Power window motor (1) Starter motor (14) Transmission fluid (3) Engine oil (10) Clock (21) Door trim panel (25) Front bumper (8) Rear bumper (12) Brake pads (12) Shift knob (8) Pump (7) Fuel pump (5) Car door (2) Instrument cluster (20) Radiator (1) Heater core (1) Heater control valve (2) Fuse box (77) Seat (7) Crankshaft position sensor (2) Engine coolant temperature sensor (2) Door lock (6) Suspension system (1) Side mirror (14) AdBlue warning light (2) Warning light – error code (32) (2) Tire pressure warning light (80) Service warning light (150) Brake drums and shoes (1) Fuel cap (8) Windshield wipers (18) Thermostat (9) Cylinder head (1) Tie rods (2) Center console tunnel (4) EGR valve (5) Blower motor (4) Side window (1) Steering wheel (6)

How to Reset the Tyre Pressure Warning Light on the Jeep Compass?

To reset the tyre pressure warning light on the Jeep Compass, inflate all tyres to the correct pressure value, which is indicated on the sticker affixed to the driver’s door pillar. Once all tyres are at this pressure, switch on the ignition and press and hold the corresponding button located to the left of the steering wheel. This will turn off the warning light, but to prevent it from reactivating, you must reset the system using an OBD scanner connected to the designated port.

Watch the video!


by ScegliAuto

More videos