Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. Glc
    4. : How do I remove the door panel of the Mercedes GLC?

Mercedes Glc - Video tutorial

Model: Mercedes Glc C253, MK 1, X253 - Years 2015-2022
Part: Door
Operation: How do I remove the door panel of the Mercedes GLC?

To be able to remove the door panel of the Mercedes GLC, you must first unhook the case which is located in correspondence with the exterior rear-view mirror. Subsequently, it will be necessary to loosen the screws that are located immediately under the power window control panel and in the part between the handrail and the glove compartment. At this point, you will need to use an object that acts as a lever to release the clips that secure the panel, starting from the bottom. By pushing the panel upwards and disconnecting its connector, it will be possible to remove and replace it.


Posted on 20 April 2024 by ScegliAuto



How to replace the front door panel in the Mercedes GLC?
Mercedes Glc (2015-2022 / C253, MK 1, X253) Replacing the front door panel in the Mercedes GLC is a very simple and fast operation, let's see how to proceed in this tutorial. We start by going
How to unlock the locked fuel tank door in the Mercedes GLC?
Mercedes Glc (2022-2024 / MK 2, X254, C254) In the Mercedes GLC, it can happen that the fuel door gets stuck, for example due to a malfunction of the control button or the lock actuator. In thi
How to mount the side step on a Mercedes GLC
Mercedes Glc (2015-2022 / C253, MK 1, X253) Let's start by removing the hooks that secure the plastic under-doors of our Mercedes GLC, and then we will have to remove the relative lower bolts.

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos