Do it yourself
Frequently asked questions about cars and motorcycles

Complete Maintenance for Mercedes A-Class W176

Model: Mercedes Classe A W176 - Years: 2012, 2013, 2014, 2015, 2016, 2017, 2018
Part: Checks and maintenance

See other generations:
Video tutorial

The use of advanced additives (so-called nanotechnology) during engine maintenance can certainly improve not only performance but also the engine's efficiency, while preserving its wear characteristics. A preliminary inspection before maintenance shows that, despite the low mileage, the engine has already begun to exhibit a slight loss of compression.

Begin by adding an additive to the diesel fuel (the fuel filter replacement for this model is recommended around 31,000 mi and it is a relatively expensive filter) and one to the oil before draining, allowing it to circulate for about 15 minutes. Then proceed with the oil and filter replacement, adding another additive.

Subsequent measurements of the same parameters already show an improvement.


Updated on 19 February 2026 by ScegliAuto


Related tutorials

Mercedes Classe A (2012-2018 / W176) This useful tutorial shows how to reset the maintenance light on your Mercedes A-Class, W176 model produced from 2012 to 2018. First, turn on the veh…
Mercedes Classe A (2012-2018 / W176) If you are looking to find the OBD port located inside the cabin of your Mercedes Class A W176, all you have to do is read the following guide and fo…
Mercedes Classe A (2012-2018 / W176) .. this new guide for all of you with a Mercedes A-Class W176 (2012-2018), we will discover where the OBD port is located and how to use it independently.. …

    Frequently Asked Questions

    • Classe A 2012-2018 - Where is the exterior temperature sensor of the Mercedes A-Class located? Read answer
    • Classe A 2018-2026 - Where is the Mercedes A-Class jack located? Read answer

How to reset the Service light on a 2019 Jeep Renegade?

The Service light, depicted as a yellow spanner, illuminates as scheduled to remind the driver that it is time for scheduled maintenance. This means that the set mileage has been reached, or the expected time has passed. The procedure involves turning on the instrument cluster, pressing the accelerator three times, and then turning off the ignition. After this, keep the brake pressed, turn the ignition back on, and then turn it off again. Upon the next ignition, you will notice that the light has been reset.

Watch the video!


by ScegliAuto

More videos