Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removal and Replacement of a Single Wiper Arm

Model: Mercedes Clk A208, W208, C208 - Years 1997-2003
Part: Windshield wipers

Gently lift the plastic covering the wiper arm near the hinge. Now, using the appropriate spanner, undo the bolt that connects the arm to the hinge. Once the bolt is undone, you can remove the entire wiper by wiggling it free. Now proceed to install the new wiper arm. Insert the arm into the designated housing in the hinge. Align the bolt hole with the hole on the hinge. Tighten the bolt and reposition the plastic covering the wiper arm. Done! The car is a Mercedes CLK.

Updated on 19 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing Windshield Wiper Blades Without a Frame
Replacing Windshield Wiper Blades Without a Frame
Mercedes Clk (1997-2003 / A208, W208, C208) Good visibility is important, especially during bad weather, so replace your wiper blades frequently. Purchase the correct wiper blade suitable for y…
Removing the Windscreen Wiper Motor
Removing the Windscreen Wiper Motor
Mercedes Clk (1997-2003 / A208, W208, C208) To remove the complete windscreen wiper motor assembly, start by opening the front bonnet and lifting it until the support catches engage. Then, remo…
Replacing the Windscreen Wiper Fuse
Replacing the Windscreen Wiper Fuse
Mercedes Clk (1997-2003 / A208, W208, C208) If the wiper system does not work or the pump located in the washer fluid reservoir does not activate to release water from the nozzles, the first th…

How to Connect the Cables to the Battery of the Citroen Xsara Picasso?

In this tutorial, you will see how to connect the cables to the battery of the Citroen Xsara Picasso, useful if you need to recharge it or perform an emergency start. First, ensure the key is not inserted, then open the bonnet and move to the front of the left headlamp. Next, locate the bolt just behind the filter box and connect the positive terminal clamp to it. Now you can connect the negative terminal to any point on the chassis, such as the indicated point. Once the operation is complete, ensure you disconnect the negative first and then the positive.

Watch the video!


by ScegliAuto

More videos