Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. MG
    3. :
  3. 5
    4. : How do you replace the brake pads on the MG 5?

MG 5 - Video tutorial

Model: MG 5 Ap12 - Years 2012-2018
Part: Brake pads
Operation: How do you replace the brake pads on the MG 5?

In order to replace the brake pads of the MG 5 you have to go and lift the car, so that you go to loosen the bolts that fix the wheels to the relative hub. When the corresponding wheel has therefore been removed, it will be possible to loosen the screws that secure the caliper to the disc, so that it is detached and the pads inside can be removed. After removal it will be possible to insert the new ones and fix the caliper again with its bolts. Finally, it will also be possible to mount the wheel, checking that the corresponding brake works correctly.


Posted on 13 May 2024 by ScegliAuto



How to replace the key battery of the MG 5
MG 5 (2012-2018 / Ap12) In this new mini guide of ours we are going to describe a method as simple as it is effective which will allow you to replace the battery in the key
How to replace cabin air filter on Mg 5
MG 5 (2012-2018 / Ap12) If we need to replace the cabin air filter using the DIY method on this car, it may be useful for us to follow the instructions below and also take a
How to replace the MG 5 air filter
MG 5 (2012-2018 / Ap12) Today we will see, in this video tutorial, how to remove and replace the MG 5 engine air filter, in simple and quick steps. First we open the bonnet

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos