Do it yourself
Frequently asked questions about cars and motorcycles

Replacing the Battery of the Mini

Model: Mini Mini R53, R50, R52 - Years: 2001, 2002, 2003, 2004, 2005, 2006, 2007
Part: Battery

See other generations:
Video tutorial

If the battery of your Mini is flat and does not hold charge after subsequent attempts to recharge it, you will need to replace it with a new one. Open the boot, remove the floor panel to access the battery compartment, unscrew the screws of the mounting bracket, disconnect the negative terminal, and then the positive terminal.

Remove the spacer that holds the battery in place and you can then lift it out using the handle provided.

Place the new battery in position, refit the spacer, tighten the positive terminal, then the negative terminal, and finally secure the bracket.


Updated on 2 October 2026 by ScegliAuto


Related tutorials

Mini (2007-2014 / R57, R56, R55) Good morning, today’s goal is to replace the key battery on our Mini Cooper. Start by prying off and removing the back cover of the key using a thin …
Mini (2001-2007 / R53, R50, R52) The battery in your Mini Cooper is located in the engine compartment. To replace it, start by opening the front bonnet. Once the bonnet is open, proc…
Mini (2017-2023 / Countryman2, F60) This guide will show you the process of removing and replacing the battery on a Mini Countryman. First, open the vehicle's bonnet and start by removi…

    Frequently Asked Questions

    • Mini 2007-2014 - Where is the Mini Cooper battery located? Read answer

How to Extract the Spare Wheel from a Mercedes Vito

The spare wheel of a Mercedes Vito is located underneath the vehicle, just below the rear boot. This video demonstrates how to extract the wheel from its compartment. First, open the boot and locate the tools provided with the vehicle to release the wheel; these can be found in a compartment on the right side of the boot. As shown in the video, use the supplied screwdriver to remove the cover cap from the hole where you will insert the socket spanner; this hole is located beneath the rubber seal above the rear bumper. Insert the spanner and attach the extension to allow you to turn it and lower the wheel from under the floor. Finally, detach the pin that allowed the wheel to lower and proceed to extract it from under the vehicle.

Watch the video!


by ScegliAuto

More videos