|
Do it yourself
| |||
| ||||
|
Model: Moto Guzzi Stelvio
To replace the rear shock absorber on the Moto Guzzi Stelvio, you need to loosen the bolts that secure it in its housing at the rear of the bike. The part will be secured by two screws, one at the top and one at the bottom: once these bolts are loosened, you can slide the part out from the lower side of the bike. This will allow you to insert the new part into its housing so that it can then be secured with the respective bolts at the top and bottom.
Updated on 22 May 2026 by ScegliAuto
Video tutorial
Related tutorials
Stelvio
To remove the rear shock absorber from the Moto Guzzi Stelvio, loosen the bolts that secure the shock absorber: it is located near the rear wheel. To…
Stelvio
To replace the rear shock absorber on a Moto Guzzi Stelvio, loosen the bolts securing it within its housing at the rear of the bike. The part will be…
Stelvio
You can replace the exhaust fitted on the Moto Guzzi Stelvio by loosening the screws that secure the exhaust terminal to its housing, located near th…
|
How to Service the Piaggio Vespa GTS 300
This brief guide will illustrate the main steps to perform the routine maintenance service on the Piaggio Vespa GTS 300, replacing the engine oil and oil filter. First, place the scooter on the centre stand and start by unscrewing the oil drain bolt found under the engine, allowing it to drain into a container for about ten minutes; then unscrew the oil filter cartridge using the appropriate tool, and hand-tighten the new one. Finally, unscrew the filler cap and top up, filling to the maximum level mark! by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.007
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
