|
Do it yourself
| |||
| ||||
Model: Moto Guzzi V35
To replace the rear brake pads of the Moto Guzzi V35, you need to loosen the screws that secure the brake caliper to the corresponding disc: the caliper is located just above the swingarm. Once the caliper is detached, you can slide out the pads located inside the caliper, after removing the corresponding retaining pin. Once the old pads are removed, you can insert the new ones into the caliper, securing it back onto the corresponding brake disc.
Updated on 20 July 2026 by ScegliAuto
Video tutorial
Related tutorials
V35
It will be possible to replace the front brake pads of the Moto Guzzi V35 by first loosening the screws that secure the brake caliper to its seat on …
V35
To replace the front brake pads on a Moto Guzzi V35, loosen the screws that secure the brake caliper to the corresponding disc: this will allow the c…
V35
In this guide, we will see the instructions that will allow us to disassemble and remove the front wheel of the Moto Guzzi V35. First, let's place th…
|
How to Service the Beta RR 350
This video will illustrate the steps to perform the routine maintenance service, replacing the engine oil and oil filter on the Beta RR 350 enduro bike. First, place the bike on a stand and start by loosening the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then clean the small oil filter (replacing it with a new one if too dirty). Finally, top up with new oil, of the correct type for your engine, filling to the maximum level! by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.006
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
