Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Fitting Parking Sensors

Model: Nissan Juke MK 1 - Years: 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019
Part: Parking sensors

See other generations:
Video tutorial

First, obtain the sensor kit. Remove the rear light of the reversing light and locate the reversing lamp wire. Connect the wire with a terminal to a ground screw and connect a positive power wire to the wire that powers the reversing lamp.

Use appropriate 'current thieves' to create a safe tap. Protect the bumper with common masking tape used for painting. Starting from the installation diagram provided in the kit, mark the installation points of the sensors on the tape.

Using a drill, start making a small hole at the marked points. Fit the hole saw of the diameter of the sensors onto the drill and enlarge the previously made holes.

Insert the sensors into the holes and route all the wires into the boot, creating a tidy wiring job. Connect all the sensors to the electronics box and install the buzzer inside the vehicle, routing the wires under the centre tunnel. Test the operation of the sensors.


Updated on 2 February 2026 by ScegliAuto


Related tutorials

How to Replace the Parking Sensors of the Nissan Juke?
How to Replace the Parking Sensors of the Nissan Juke?
Nissan Juke (2010-2019 / MK 1) To replace the parking sensors of the Nissan Juke, first extract the control unit from the side cover located inside the boot. Once the control unit …
How to Reset the Tyre Pressure Warning Light on a Nissan Juke?
How to Reset the Tyre Pressure Warning Light on a Nissan Juke?
Nissan Juke (2010-2019 / MK 1) The tyre pressure warning light that appears on the instrument cluster of the Nissan Juke can be reset by inflating the tyres to the recommended pres…
How to remove the rear bumper from the Nissan Juke
How to remove the rear bumper from the Nissan Juke
Nissan Juke (2010-2019 / MK 1) Removing the rear bumper from a Nissan Juke takes about 30 to 40 minutes and requires some screwdrivers and plastic tools. Start with the wheel arche…

How to Replace the Glow Plugs in the Fiat Ducato 2.3 Multijet?

Glow plugs, as the name suggests, raise the temperature of the engine in diesel vehicles to allow for easier starting. The manufacturer, in this case, Fiat for the Ducato 2.3 Multijet, specifies how often they should be replaced, and a warning light will illuminate when it's time. This work is carried out under the bonnet. First, remove the upper engine cover, then lift the coil and, using a socket wrench of the appropriate size, unscrew the glow plug to remove it from the base, followed by installing the new one.

Watch the video!


by ScegliAuto

More videos