Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing Rear Brake Shoes on Opel Corsa

Model: Vauxhall Corsa Corsa C - Years 2000-2006
Part: Brake pads

Hello everyone! In this video tutorial, you will see how to change the rear drum brake shoes on an Opel Corsa. First, lift the car off the ground and remove the wheel: now take a screwdriver and pry off the central cover of the drum to remove it. Next, using a 27 mm socket, loosen the central nut that will allow you to take out the drum. Once removed, disconnect the springs of the brake shoes, possibly using pliers and a screwdriver: remove the retaining clips and extract the brake shoes!

Updated on 18 March 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Front Brake Pads on the Opel Corsa D
Replacing the Front Brake Pads on the Opel Corsa D
Vauxhall Corsa (2006-2014 / Corsa D) In today's video, learn how to remove and replace the front brake pads on the Opel Corsa D, following the instructions below. First, lift the vehicle…
How to Replace the Front Brake Pads on an Opel Corsa
How to Replace the Front Brake Pads on an Opel Corsa
Vauxhall Corsa (2006-2014 / Corsa D) Before you begin, ensure the car is in first gear and the handbrake is engaged on your Opel Corsa. Next, unscrew and remove the cap from the brake fl…
Replacing Brake Pads
Replacing Brake Pads
Vauxhall Corsa (2006-2014 / Corsa D) Lift the vehicle on suitable axle stands and remove the front wheel (it is suggested to perform this operation after the vehicle has been stationary …

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos