Do it yourself
Frequently asked questions about cars and motorcycles

Replacing the Rear Headlamp Bulb

Model: Vauxhall Corsa Corsa D - Years 2006-2014
Part: Tail light bulb

To replace the rear light bulbs, you need to remove the entire light assembly. The screw is accessible on the side of the boot after removing the side cover. Use a plastic tool to lever and remove the sound-absorbing polystyrene panel from the designated slot. Unscrew the large retaining knobs of the headlamp located under the cover and remove the light by disconnecting the connectors. Carefully remove the bulb holder and replace the faulty bulb by pressing it slightly and turning it anti-clockwise until it releases. Refit the new bulb using one with the same specifications. Reposition the light assembly in its housing by connecting the relevant connector. Tighten the fixing screw carefully and close the cover.

Updated on 7 February 2026 by ScegliAuto

This video is currently unavailable

Related tutorials

Vauxhall Corsa (1993-2000 / Corsa B) Is the rear headlamp bulb not working? Let’s replace the bulbs. Open the boot lid, remove the inspection cover (located at the side of the boot) and …
Vauxhall Corsa (2000-2006 / Corsa C) To replace the rear headlamp bulb, you must first remove the headlamp itself: open the rear bonnet, unscrew the fixing screws of the headlamp located…
Vauxhall Corsa (2000-2006 / Corsa C) This video illustrates the procedures for removing and replacing the bulb of the rear headlamp on your car. First, remove the plastic cover of the he…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos