Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing the Heating Radiator from the Opel Corsa

Model: Vauxhall Corsa Corsa D - Years 2006-2014
Part: Heater core

Follow the procedure to remove and replace the heating radiator in the Opel Corsa. First, open the bonnet of your car and disconnect the radiator fluid pipe, allowing it to drain into a container. Next, get inside the vehicle on the passenger side and remove the plastic cover from the centre tunnel located under the glove compartment, as shown in the video. At this point, undo the screws securing the heating radiator and disconnect the fluid pipe from the exchanger. Remove and replace the matrix with the new one, ensuring to bleed the heating system.

Updated on 6 July 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacement of the Opel Corsa's cabin heating radiator
Replacement of the Opel Corsa's cabin heating radiator
Vauxhall Corsa (2000-2006 / Corsa C) Today's main steps will show us how to disassemble and replace the heater radiator of the Opel Corsa. First, we open the car's hood and start disconn…
Replacing the Heater Radiator on an Opel Corsa
Vauxhall Corsa (1993-2000 / Corsa B) Replace the heater radiator if warm air no longer works, here's how. Remove the plastic covers from the central tunnel (near the pedals). Unscrew the…
Guide to Replacing the Cabin Heater Radiator on the Opel Corsa
Guide to Replacing the Cabin Heater Radiator on the Opel Corsa
Vauxhall Corsa (2000-2006 / Corsa C) Below are the instructions that will allow you to replace the coolant in the Opel Corsa. First, open the bonnet of the vehicle and start disconnectin…

Other guides you may be interested in

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos