Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Change the Rear Headlamp Bulb on an Opel Insignia

Model: Vauxhall Insigna MK 1, Insigna A - Years: 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017
Part: Tail light bulb

See other generations:
Video tutorial

To perform this operation, open the boot lid to access the rear compartment where the fixings for each headlamp are located on either side of the boot. Remove the rigid plastic cover secured with a clip at the back.

Now, unscrew the two black rigid plastic butterflies to release the headlamp, which you should hold from the other side. Pull the headlamp towards you and disconnect the connectors at the back to fully extract it. This allows you to make the necessary replacements and reassemble everything.


Updated on 26 February 2026 by ScegliAuto


Related tutorials

How to Remove the Rear Light of an Opel Insignia
Vauxhall Insigna (2008-2017 / MK 1, Insigna A) Before starting, open the tailgate of the boot of your Opel Insignia. Begin by disengaging and removing the inner side cover located near the rear li…
How to Remove the Headlight Bulb on an Opel Insignia
How to Remove the Headlight Bulb on an Opel Insignia
Vauxhall Insigna (2008-2017 / MK 1, Insigna A) How do you remove the headlight bulb? Let's see how to remove the bulb from the headlight of an Opel Insignia. Lift the bonnet, locate the inspection…
How to Remove the Rear Light on an Opel Insignia?
How to Remove the Rear Light on an Opel Insignia?
Vauxhall Insigna (2008-2017 / MK 1, Insigna A) To remove the rear light on an Opel Insignia, open the tailgate to access the boot. Here, remove the carpet cover located near the light to be replac…

How to reset the Service light on a 2019 Jeep Renegade?

The Service light, depicted as a yellow spanner, illuminates as scheduled to remind the driver that it is time for scheduled maintenance. This means that the set mileage has been reached, or the expected time has passed. The procedure involves turning on the instrument cluster, pressing the accelerator three times, and then turning off the ignition. After this, keep the brake pressed, turn the ignition back on, and then turn it off again. Upon the next ignition, you will notice that the light has been reset.

Watch the video!


by ScegliAuto

More videos