|
Do it yourself
| |||
| ||||
|
Model: Peugeot Citystar 125
To replace the front brake pads on a Peugeot Citystar 125, loosen the screws that secure the caliper to the disc, both at the top and bottom. Once the screws are loosened, detach the caliper from the disc and use a screwdriver to pry inside to extract the old pads. After removing them, insert the new replacement parts and position the caliper back onto the disc. Finally, secure it by tightening the bolts at the top and bottom.
Updated on 8 June 2026 by ScegliAuto
Video tutorial
Related tutorials
Citystar 125
To replace the front brake pads of the Peugeot Citystar 125, you need to loosen the screws that secure the brake caliper to its housing: this will al…
Citystar 125
Today, in this video tutorial, you will learn how to remove and replace the rear brake pads on a Peugeot Citystar 125 scooter. First, remove the sile…
Citystar 125
To replace the brake fluid on a Peugeot Citystar 125, you need to connect the tube to the corresponding brake caliper: this will allow you to pump th…
|
How to Service the Beta RR 350
This video will illustrate the steps to perform the routine maintenance service, replacing the engine oil and oil filter on the Beta RR 350 enduro bike. First, place the bike on a stand and start by loosening the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then clean the small oil filter (replacing it with a new one if too dirty). Finally, top up with new oil, of the correct type for your engine, filling to the maximum level! by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.007
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
