Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. 207
    4. : How to replace spark plugs on Peugeot 207

Peugeot 207 - Video tutorial

Model: Peugeot 207 MK 1 - Years 2006-2015
Part: Spark plugs
Operation: How to replace spark plugs on Peugeot 207

Disassembly of the spark plugs on a Peugeot 207, we see the disassembly of the pieces. We open the engine compartment and lift the front hood, put it in safety, disconnect the battery terminals. We disassemble the motor cover panel, remove the coils on the head of the motor with a screwdriver; immediately afterwards we unscrew the candles with a socket wrench, take them out of the head. We take the new spark plugs and accompany them with the socket wrench extension in the engine head, tighten them and connect the power coils to each spark plug with the new ancestors. We close the engine compartment, turn on our 207 and test the operation.


Posted on 2 December 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • 207 2006-2015 - When should the spark plugs of a Peugeot 207 be replaced? Read Answer
    • 207 2006-2015 - When should the spark plugs of a Peugeot 207 be replaced? Read Answer
    • 207 2006-2015 - How much do the Peugeot 207 1.4 spark plugs cost? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos