Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Driver's Seatbelt

Model: Peugeot 406 MK 1 - Years: 1995, 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005
Part: Seat

Video tutorial

To replace the driver's seatbelt, proceed as follows: remove the plastic cover from the side of the seat and unscrew the seatbelt's mounting bolt; remove the inner seals from the front and rear doors; detach the plastic cover from the central pillar and slide the seatbelt out of the passage hole; remove the guide bracket from the pillar and the plastic cover from the scuff plate; then unscrew the seatbelt mounting bolts from the pillar and reverse the process for reassembly, ensuring the seatbelt is routed correctly.


Updated on 8 February 2026 by ScegliAuto


Related tutorials

Repairing and Resetting Airbag Faults
Repairing and Resetting Airbag Faults
Peugeot 406 (1995-2005 / MK 1) If the airbag warning light remains on the vehicle display, the first step is to check the fault memory with a diagnostic tool, even a generic one. O…
How to Remove the Seatbelt from its Reel
How to Remove the Seatbelt from its Reel
Peugeot 406 (1995-2005 / MK 1) First, remove the cap on the side with the white square, push the plastic rivet through the hole, and lift the cap. Next, pull the seatbelt all the w…
Replacing Dashboard Light Bulbs
Replacing Dashboard Light Bulbs
Peugeot 406 (1995-2005 / MK 1) Replacing the backlighting lights of the climate control display is very simple. Using a small flathead screwdriver, detach the caps located on the s…

How to Replace the Starter Motor on an Opel Corsa?

In this tutorial, you will see how to replace the starter motor on an Opel Corsa C, a relatively simple task if you have good manual skills. First, open the bonnet, then disconnect the negative terminal of the battery to work safely. Next, locate the device at the rear of the engine, remove the intake manifold, and unscrew the two nuts from the power terminals. At this point, you can unscrew the mounting bolts of the starter motor, separate it from the engine, and install the replacement by following the reverse procedure.

Watch the video!


by ScegliAuto

More videos