Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. 406
    4. : Complete internal disassembly instructions

Peugeot 406 - Video tutorial

Model: Peugeot 406 MK 1 - Years 1995-2005
Part: Seat
Operation: Complete internal disassembly instructions

To be able to disassemble the interior of the car in question, proceed as follows: start by unscrewing the fastening pins of the front seats in correspondence with the four corners of the sliding rails and then remove them after disconnecting the airbag pretensioners socket; then remove the plastic caps placed to protect the fixing pins of the rear seat seat and then remove it; therefore unscrew the fixing pins of the sides of the backrest and of the backrest itself; remove the carpet from the luggage rack, fold the backrest and complete the disassembly of the pins. You can continue by removing the seat belts and the parcel shelf lining (there are press-studs). The speakers are then fixed with plastic nuts: just unscrew them to remove them. The plastic trims of the rear pillars are fastened with snap clips, as is the plastic trim of the bonnet. Finally, in order to completely remove the carpet, the central tunnel, the door pillar trim and the door sills must be removed.


Posted on 28 July 2023 by ScegliAuto

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos