Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Instructions for Removing the Driver's Airbag

Model: Peugeot 406 MK 1 - Years: 1995, 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005
Part: Airbag

This video is currently unavailable

If the horn does not work and the airbag warning light remains on, it could be a simple contact issue caused by oxidation, or a fault in the spiral cable integrated into the light switch; start by disconnecting the airbag by inserting a screwdriver into the appropriate holes behind the spokes of the steering wheel to press and release the retaining springs; once the airbag is disconnected and the relevant connectors are unplugged, clean the contacts inside the steering wheel plate before removing the steering wheel and the light switch; at this point, check the continuity of the internal ribbon before refitting it: if broken, it will need to be replaced and attempting to repair it is not recommended.


Updated on 22 February 2026 by ScegliAuto


Related tutorials

Repairing and Resetting Airbag Faults
Repairing and Resetting Airbag Faults
Peugeot 406 (1995-2005 / MK 1) If the airbag warning light remains on the vehicle display, the first step is to check the fault memory with a diagnostic tool, even a generic one. O…
Instructions for Dismantling Dashboard Elements
Instructions for Dismantling Dashboard Elements
Peugeot 406 (1995-2005 / MK 1) The first operation is to remove the plastic covers of the light switch controls: unscrew the fixing screws and separate the two covers; then remove …
Instructions for Complete Interior Disassembly
Instructions for Complete Interior Disassembly
Peugeot 406 (1995-2005 / MK 1) To disassemble the interior of the vehicle in question, proceed as follows: start by unscrewing the fastening bolts of the front seats located at the…

Other guides you may be interested in

How to Replace the Starter Motor on an Opel Corsa?

In this tutorial, you will see how to replace the starter motor on an Opel Corsa C, a relatively simple task if you have good manual skills. First, open the bonnet, then disconnect the negative terminal of the battery to work safely. Next, locate the device at the rear of the engine, remove the intake manifold, and unscrew the two nuts from the power terminals. At this point, you can unscrew the mounting bolts of the starter motor, separate it from the engine, and install the replacement by following the reverse procedure.

Watch the video!


by ScegliAuto

More videos