Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Install the Bell and Clutch on the Piaggio Ciao

Model: Piaggio Ciao
Part: Clutch

Video tutorial

Today, you will learn how to install the bell and clutch on the 1970 Piaggio Ciao. To perform the installation, you will need: a 50 pence coin, a 13mm combination spanner, a filter wrench, a flat screwdriver, and a small screwdriver. Ensure that the clutch belt is oiled but clean and that the shaft and oil seal do not have excess oil. Insert the clutch into the belt and pull firmly to fit the clutch onto the hub shaft at the top of the bell housing.

Use the flat screwdriver to adjust the bell so that the half-moon is horizontal and hand-tighten the outer nut. Use the filter wrench to tighten the bell and clutch. With the 13mm spanner, tighten the hub clockwise.

Finally, secure the side panel and use the small screwdriver or the 50 pence coin to tighten the screws.


Posted on 20 April 2026 by ScegliAuto


Related tutorials

How to disassemble the clutch of the Piaggio Ciao - Si - Bravo
How to disassemble the clutch of the Piaggio Ciao - Si - Bravo
Ciao Today's steps will show us how to disassemble and replace the clutch of the Piaggio Ciao, as well as the Si and the Bravo. First, we put the center s…
Removing the Belt and Clutch on a Piaggio Ciao
Removing the Belt and Clutch on a Piaggio Ciao
Ciao In today's video, you will see how to remove the drive belt and clutch on a Piaggio Ciao in simple steps. First, secure the rear wheel, perhaps by in…
How to Replace the Belt on the Piaggio Ciao
How to Replace the Belt on the Piaggio Ciao
Ciao To replace the belt on the Piaggio Ciao, loosen the screws securing the protective panel on the side of the bike, located between the seat and the re…

How to Replace the Rear Brake Pads on a Derbi Senda 125?

To replace the rear brake pads on a Derbi Senda 125, loosen the nut that secures the central axle of the rear wheel so that it can be completely removed from its housing. Once the wheel is removed, you can slide out the pin that secures the pads inside the brake caliper and remove them from their housing. After the old pads have been removed, insert the new replacement parts, securing them with the pin. Finally, reinstall the rear wheel, positioning it at the end of the swingarm.

Watch the video!


by ScegliAuto

More videos